| WaGuns.org https://www.waguns.org/ |
|
| Any AK Gunsmiths? https://www.waguns.org/viewtopic.php?f=26&t=146355 |
Page 1 of 1 |
| Author: | donaldw253 [ Wed Apr 17, 2024 7:52 pm ] |
| Post subject: | Any AK Gunsmiths? |
Any local gunsmiths familiar on stamped AK’s? I have a Chinese AK built on a B-West receiver (I know here come the comments), some of the pin holes are wallowing out and possibly re heat treat. |
|
| Author: | Gunnerboy [ Thu Apr 18, 2024 7:34 am ] |
| Post subject: | Re: Any AK Gunsmiths? |
Even re heat treated it will break. Those receivers had issues even after heat treat. Best option is a Childers but that won't happen here in WA. |
|
| Author: | xman [ Thu Apr 18, 2024 7:39 am ] |
| Post subject: | Re: Any AK Gunsmiths? |
There is no good way to repair it. You could weld the trigger pivot pins in. The carrier guide rails are going to wear out next. You could cut the old ones out and weld new ones in. Never seen anyone repair these Bwest USA Tucson AZ receivers. They are usually cut and sold as a parts kit. Is it a spiker or red bakelite version? |
|
| Author: | donaldw253 [ Fri Apr 19, 2024 7:49 pm ] |
| Post subject: | Re: Any AK Gunsmiths? |
It’s an underfolder with wood furniture. |
|
| Author: | Gunnerboy [ Tue Apr 23, 2024 6:17 am ] |
| Post subject: | Re: Any AK Gunsmiths? |
Unfortunately it needs a replacement receiver which isn't possible in the Soviet republic of seattlestan.. but things do get found around traveling to the USA. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|