| WaGuns.org https://www.waguns.org/ |
|
| Remington 597 Trigger Job https://www.waguns.org/viewtopic.php?f=35&t=1761 |
Page 1 of 1 |
| Author: | NebraskaGunner [ Wed Aug 10, 2011 7:58 pm ] |
| Post subject: | Remington 597 Trigger Job |
I've had this 597 for about 10-15 years now, and never thought much about the trigger. Then one day i some how came across this "target trigger hammer" from Volquartsen. Every review I read was 4+ stars and there was nothing bad said about it, so I decided to plop out the $40 with shipping and see. maybe the $40 part I have put in any gun. Trigger weight is easily 1/2 of what it was. I'm not sure what the factory weight is but it's way better now. If you have a Remington 597 you NEED to pick one of these up. Install time was under 10 minutes. For those that have a 597: http://www.rimfiresports.com/merchant.m ... Code=VCRTH |
|
| Author: | Massivedesign [ Wed Aug 10, 2011 8:02 pm ] |
| Post subject: | Re: Remington 597 Trigger Job |
Great review! Was installation a breeze? |
|
| Author: | NebraskaGunner [ Wed Aug 10, 2011 8:10 pm ] |
| Post subject: | Re: Remington 597 Trigger Job |
It was, and I'll be honest; outside of high school shop, I'm lost. The hammer didn't come with any instructions, so I thought "I'll just take a look inside." 6 minutes later I was done. I just read online the new trigger pull weight should be in the 2.5-3.0lb range. I think factory is 5.5lb+++. |
|
| Author: | MadPick [ Wed Aug 10, 2011 9:02 pm ] |
| Post subject: | Re: Remington 597 Trigger Job |
I love to read this stuff! (And no, I don't even have a 597.) Thanks for sharing! |
|
| Author: | G-19 [ Thu Aug 11, 2011 8:24 am ] |
| Post subject: | Re: Remington 597 Trigger Job |
What MadPick said. I feel like such a gun nerd... |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|