| WaGuns.org https://www.waguns.org/ |
|
| Need help with 10/22's https://www.waguns.org/viewtopic.php?f=26&t=89321 |
Page 1 of 1 |
| Author: | movingviolation [ Thu Mar 15, 2018 6:53 pm ] |
| Post subject: | Need help with 10/22's |
So i've got 2 of them, bought them used, they were working fine I've been shooting them for a while and then came the time to clean them Cleaned them, assembled back, all fits, no extra parts left Now they shoot but don't cycle fully, shells are either FTE and get jammed half way out or don't even come out of the chamber anyone have an idea of wtf did i do wrong? i tried disassembling and reassembling them but results are the same... |
|
| Author: | TINCANBANDIT [ Thu Mar 15, 2018 7:30 pm ] |
| Post subject: | Re: Need help with 10/22's |
I could take a look at them, get a hold of me next week |
|
| Author: | delliottg [ Thu Mar 15, 2018 7:48 pm ] |
| Post subject: | Re: Need help with 10/22's |
Take a look at your trigger groups. It's relatively easy to get things crossed up. Make sure all the plates are perpendicular to the pins. I've had this happen a couple of times when I wasn't paying attention with the same results you're describing. |
|
| Author: | TacticalAssault [ Thu Mar 15, 2018 8:16 pm ] |
| Post subject: | Re: Need help with 10/22's |
Stuck floating ejector or the op rod (recoil rod) not seated in its receptacle in the rear of the receiver. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|