These were included in a PIF that I received from Tombrewster421, and I'd like to pass them along. Thank you again, Tom!
See the photo below; included are a used set of Lee dies for 6.5 Carcano, plus a new "Case Length Gauge and Shellholder" set, also for 6.5 Carcano.
Note that the dies have a little surface rust on them. I didn't try to use them (as I already have dies), but I'm sure they work just fine. Also note that the seater die won't work for the larger 0.268" bullets that some folks load for the Carcano, but they will work just fine for the more typical 0.264" bullets. (The hole inside is too small to allow the larger bullets to pass through, but it's larger on my newer Lee die set . . . FYI.)
If you are interested, just say "in" or similar. Please specify whether you'd like one or both of these items.
I'm happy to either meet the winner in the Renton area, or mail these on my dime.
I'll close the PIF when it feels right to do so.