NWRed wrote:
Anyone have the tools and experience to bend a 8' piece of 3/4" steel into a 90 degree angle with an approx. 36" radius about midway on the 8' stick.
36" CLR is rolled, not bent. clamp it to a 55 gallon drum and start heating and wrapping it around. It will go faster then you think with a decent bud a oxy/ace torch.
You can even cold bend it with a strap, truck and a 30" tree.
How precise and clean does it have to be? Intended purpose?
I have jd2/hossfeld, a bendpak exhaust machine and a press brake but no roller.
It can be bent gradually over a drawn out area with a smaller radius die.