WaGuns.org https://www.waguns.org/ |
|
Quietbore Form 1 https://www.waguns.org/viewtopic.php?f=41&t=116318 |
Page 1 of 1 |
Author: | I'm10-4 [ Mon Dec 28, 2020 9:55 am ] |
Post subject: | Quietbore Form 1 |
Considering doing a Form 1 Quietbore can for .22. Has anyone gone with Quietbore before? Does anyone have a better recommendation? |
Author: | Guns4Liberty [ Mon Dec 28, 2020 11:10 am ] |
Post subject: | Re: Quietbore Form 1 |
Quietbore is legit...I'm not sure there are really any better options out there, honestly. |
Author: | edogg [ Mon Dec 28, 2020 2:57 pm ] |
Post subject: | Re: Quietbore Form 1 |
Yeah, the jig is pretty nice. Sent from my iPhone using Tapatalk |
Author: | token3495 [ Tue Dec 29, 2020 3:11 pm ] |
Post subject: | Re: Quietbore Form 1 |
I'm planning to pick up one of these - https://pewpewsolutions.com/product/sweetti-ti-6al-4v-grade-5-premium-sauce-storage-device-2/ |
Author: | scrid2000 [ Tue Dec 29, 2020 6:59 pm ] |
Post subject: | Re: Quietbore Form 1 |
token3495 wrote: I'm planning to pick up one of these - https://pewpewsolutions.com/product/sweetti-ti-6al-4v-grade-5-premium-sauce-storage-device-2/ |
Author: | I'm10-4 [ Tue Dec 29, 2020 6:59 pm ] |
Post subject: | Re: Quietbore Form 1 |
One thing I liked with the quietbore was the fact you could buy jigs. How are you planning on drilling the baffles? |
Author: | token3495 [ Wed Dec 30, 2020 8:54 am ] |
Post subject: | Re: Quietbore Form 1 |
scrid2000 wrote: token3495 wrote: I'm planning to pick up one of these - https://pewpewsolutions.com/product/sweetti-ti-6al-4v-grade-5-premium-sauce-storage-device-2/ I can only assume they are being conservative and wanting to deter people from throwing it on the end of a 10.5" 556 AR and mag dumping it. I'm10-4 wrote: One thing I liked with the quietbore was the fact you could buy jigs. How are you planning on drilling the baffles? I have access to an end mill. However I have used WTT's jigs in the past but I don't think they offered one for this. If you have access to a 3D printer, there is an open source jig for these and all you need to do is buy an insert from McMaster Carr Jig: https://www.thingiverse.com/thing:4483955 Insert: https://www.mcmaster.com/8492A176/ |
Page 1 of 1 | All times are UTC - 8 hours |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |